THE MODEL ET-95-V IS IDENTICAL TO THE HORIZONTAL MODEL EXCEPT THAT IT IS MOUNTED IN THE VERTICAL POSITION. MANY SHOPS PREFER THE VERTICAL UNIT BECAUSE OF SPACE. WITH THE VERTICAL UNIT, THE BENT TUBE SWINGS UP IN THE AIR. THE HORIZONTAL UNIT SWINGS THE TUBE HORIZONTALLY REQUIRING MORE FLOOR SPACE DEPENDING ON THE PRODUCT BEING PRODUCED.

• MACHINE IS MOTOR DRIVEN AND HYDRAULIC POWERED
• PLC SYSTEM TO CONTROL MANUAL OR AUTOMATIC CYCLES
• 5 HP TO 25 HP (CUSTOMER SPECIFIES HOURLY BEND RATE)
• 230 - 440 VOLTS, 3 PHASE, 50/60 CYCLE
• 3000 - 5000 PSI HYDRAULIC SYSTEM PRESSURE
• 3- 15 GPM HYDRAULIC PUMP
• 24 VOLT MICRO SWITCHES
• 2 PALM BUTTON BEND CYCLES MANUAL OR AUTOMATIC
• BEND CAPACITY FROM 1/2" (12.7MM) TO 3" (76.2MM) DIAMETER TUBE
• BEND RADIUS FROM 3" (76.2MM) TO 6" (152.4MM)
• 3/8" (9.5MM) MINIMUM RADIUS FOR SQUARE TUBE
• TOOL CHANGEOVER TIME ABOUT ONE MINUTE
• SEMI-AUTOMATIC BEND CYCLE OR AUTOMATIC BEND CYCLE
• MANUAL BEND READOUT FOR PROTOTYPE BENDING
• COMPLETELY SELF CONTAINED
• 1" (25.4MM) TO 2" (50.8MM) DIAMETER PIPE CAPACITY X 1/2" (12.7MM) WALL THICKNESS
• AMCO BRONZE BUSHINGS
• AMCO BRONZE WEAR PLATES ON MOVING GATE ASSEMBLY
• HARDENED WEAR PLATES ON BEND HEAD