THE MODEL 3212-SA-2P IS SEMI-AUTOMATIC TUBE END FORMING MACHINE. IT IS SELF CONTAINED. ELECTRICAL DRIVEN HYDRAULIC POWERED. THIS UNIT HAS A FORMING CAPACITY OF 291/2 TONS. THIS UNIT WILL EXPAND, REDUCE, FLARE, FLANGE OR BEAD THE ENDS OF TUBES. THIS UNIT ALLOWS FOR PRECISION FORMING SINCE THE FORM STROKE IS CONTROLLED BY PROXIMITY SWITCHES. IT UTILIZES A PLC SYSTEM THAT ALLOWS FOR CONTROLLED SEQUENCE OF OPERATION. IT HAS (2) PALM BUTTONS FORM OPERATION. MANUAL JOB SET-UP CAN BE ACCOMPLISHED BUT STILL USING (2) HANDS FOR ADDED SAFETY. IT HAS AN AIR SYSTEM THAT CONTROLS THE TUBE STOP ASSEMBLY. THIS ASSEMBLY ALLOWS CONTINUED PRECISE POSITIONING OF THE TUBE PRIOR TO FORMING. PRODUCTION RATES VARY DEPENDING ON TYPE OF FORM, MOTOR AND PUMP COMBINATION. THIS UNIT WILL PRODUCE PRODUCT WITHOUT MARRING THE TUBE.

• UNIT IS A LOWER PRODUCTION THEN MODEL 3212-A-2P
• 230 VOLTS, 3 PHASE, 50/60 CYCLE
• PLC SYSTEM TO CONTROL ALL FUNCTIONS OF THE MACHINE MANUAL OR AUTOMATIC
• 5 HP ELECTRIC MOTOR
• 3 GPM HYDRAULIC PUMP
• 3000 PSI MAXIMUM HYDRAULIC SYSTEM PRESSURE
• 24 VOLTS PROXIMITY SWITCHES
• (2) 24 VOLT PALM BUTTONS
• 20 TONS OF FORM AND CLAMP FORCES
• APPROX 6" MAXIMUM REDUCTION DEPTH
• MACHINE CAN EXPAND, REDUCE, FLARE, FLANGE OR BEAD
• COMPLETE SELF CONTAINED HYDRAULIC SYSTEM
• 100 PSI SHOP AIR FOR ROTARY ACTUATOR TO OPERATE THE TUBE STOP POSITION ARM
• DEPENDING ON DIAMETER OF TUBES TO BE FORMED, TWO DIAMETERS CAN UTILIZE ONE SET OF CLAMP COLLARS
• ALL TOOLING MADE FROM TOOL STEEL AND HEAT TREATED
• APPROX FORM CYCLE TIME TO REDUCE OR EXPAND 4" (101.6MM) DEEP - 10-14 SECONDS
• ALL PINCH POINTS GUARDED