PIPE SWAGING MACHINE MODEL 3234-HHD-3ST

This model is designed for swaging or pointing heavy wall pipe. The diameter of reduction is controlled in stages. 3 or 4 stages are available depending on the model. The length of reductions is controlled by electronic proximity switches which determine the stroke of the forming cylinder. This unit will operate in the manual or automatic mode. A PLC drives all electronic functions of the unit. All controls are mounted on an easy access control panel. A tube stop is attached in order to repeat the exact length of reduction.

SPECIFICATIONS 230 - 460 Volts 50 - 60 Cycles, 3 Phase 25 HP Electric Motor High - Low Hydraulic Pump 5 - 15 GPM Pump 5000 PSI Maximum Hydraulic System Pressure 95 Tons of Clamping & Forming Forces 24 Volts Proximity Switches to control clamp and form cycles 3 Station tooling mounting Automatic lubrication system Tube stop assembly to insure precise forming of each pipe PLC system used for all forming cycles; manual or automatic Safety cover shield on clamp and forming head assembly.	A mar free hydraulic clamp grips the pipe and a clean surface is left after forming. Clamp changeover time is less then 10 minutes. Dies are made of tool steel for long wear life All stations use reducing inserts for each stage of forming. Inserts changeover time is no more then 5 minutes for all 3 stations.	This system will lubricate the pipe ends for each cycle. It will turn itself on/off with a time cycle programmed in the PLC  The length of reduction is controlled by proximity switches rate at 24 volts